Are there any recommended settings for response curves or anything at all to help with trimming in xplane? At the moment I'm finding it very difficult to trim the plane for level flight or a consistent descent on an ILS/RNAV, I seem to end up constantly holding it and the pressure required is tiring, or I go over the opposite direction.

I hooked up my Cirrus Side yoke to Xplane last night and it went great, everything works really well. Then I went and hooked it up to MSFS2020 and tried to fly the SR22 with it. What I observed was that unlike XPlane when I move the yoke around the onscreen yoke reacts quite slowly to input from the physical yoke. in that if I roll to the right I have to hold it there for a second or more before the yoke on the screen turns right, then if I let it go and center it doesn't come back I have to actually turn it to the left to bring the yoke back centered. Has anyone else seen this sort of behaviour it makes flying the plane quite impossible.