I noticed the same with my system. It seems to have happened with the last update. I am using x-plane and the airport is KCHA, ILS RWY 2, Loc I-CGW 27/01/22-24/02/22 Plate

I too experience the same issue. as above. Is there something that can be done to reduce trim per click?

Don: I never did use the Brunner with NFS. When I received the NFS H/W and S/W I set it up on a new computer and have not used the Brunner since. I am sure mine would react the same as yours. Terry

Don: I have the Brunner Yoke, but replaced it with the NFS Cirrus Yoke, so that is why I did not see the same effect as you did. Thanks for the update. Terry

When I fly the 172 in X-Plane my NFS FD & NAV are displayed only on the NFS PDF/MDF. Engaging AP from NFS does guide the 172 even though the FD & NAV info are not reflected on 172 PDF/MDF.

Don: I am running X-Plane Pro and I experienced a similar problem with my system. The following is the procedure that worked for me. Sometimes after initial setup the hardware needs a reset. To do this, close both the NFS software and the flight sim. Unplug the power cable where it connects into the Y splitter and then plug it back in after a second or two. Wait for the backlighting to come back on. Press and hold the lower left bezel power buttons a few seconds to turn the displays back on Reload the NFS software and the hardware should be working. If you are using the VGA to DP cables to connect the PFD and MFD to your computer, apparently this will happed periodically. I changed my connections to DP on both ends and I have not needed to do the above reset to date. Changing the cables for HDMI apparently will achieve the same thing. I hope this works for you. Terry